Posted by rrlund on June 13, 2014 at 12:09:04 from (162.250.26.144):
I got that Vicon discbine at that auction today. Gave $1400 for it. I figured for that price,I'd take a chance. There are a few poly/plastic pieces missing off the rolls. I wonder if those are available and can be slid on over the end of the shaft? They look like that slide on that square shaft. It fit on the trailer like a glove. I just had to take the angle iron stop off the swing cylinder,then we plugged it in to the auctioneer's loader tractor and it swung right around. I had a flat tire on the center axle of the trailer on the way home but I was only about a mile and a half from a Gehl,Kuhn/Knight dealer,so I swung in there and had them jack it up and change it with the impact wrench. I'll get the darned thing unloaded and see how bad I got beat up.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Proflie: Farmall Model C - by Staff. In 1948 the first Farmall Model C tractor rolled out of the factory and into the farmer's field. A follow-on to the Model B, it was slihtly larger in size but kept the same 113 CID engine and 4-speed transmission. Other upgrades included adjustable rear tire spacing (with sliding hubs), a frame design similar t
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
