Posted by buickanddeere on May 25, 2014 at 13:24:02 from (216.183.152.35):
In Reply to: Deere 60 sputters posted by Samtn1 on May 25, 2014 at 05:05:04:
Who was the professional shop that rebuilt the carb? Somebody like Robert's carburetor?
If it was the local shop in town, I have my doubts. The duplex carb has some well hidden passages that 99% of carb re-builders will miss unless the passages/orifices are pointed out.
If going into the engine far enough to bore it. Did you pull the cam and followers for a re-grind? at their age and hours they have to be worn to some degree.
I was always baffled at how thousands can be sunk into a rebuild but a $100 cam re-grind gets missed ? :?:
A soft valve spring does occur on occasion.
This post was edited by buickanddeere at 13:27:09 05/25/14.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
