Posted by DaninKansas on May 23, 2014 at 10:00:15 from (24.248.193.103):
In Reply to: A Good Deal? posted by Bryce Frazier on May 23, 2014 at 07:30:49:
The issue will be the knotter. If you get the right person that knows what they are doing it "COULD" be working fine with just an hour or so's worth of labor.
I had a JD 14T baler that I bought from a 80 year old neighbor that said it worked fine for him the last time he used it - about 8 years earlier before he parked it in the shed. I set it up and baled a little bit with it and found that it failed to tie one in twenty bales on one side. If I had just run it a little longer and let all the kinks work out it probably would have been fine.
Instead I thought I would be proactive and get it working right before I shoved a lot of hay through it. I talked to the local JD stealership and "Yeah we got a guy that knows all about them". $1600 later I had a baler that wouldn't tie on one side at all. It never made another bale again and I get $300 for it at the scrap yard.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Converting from 6 Volt to 12 Volt - by Chris Pratt. It's a common problem for old machines especially when the weather starts to dip below 40 and the tractor isn't fired up as often. You are probably used to the 12 volt Diehard, charged with 200 amp alternator of your 3/4 ton that always is ready and always starts. It's this type of experience that brings about the many queries we get for 12-volt conversion kits. Since only a few kits are available (we sell kits for the
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
