Posted by Moline_guy on May 16, 2014 at 20:00:47 from (216.106.219.202):
In Reply to: 1586 posted by Zach Scherf on May 16, 2014 at 17:49:00:
Good all around tractor as far as I am concerned. Some have been switched over to dual pto's, most are small 1000 shafts. Most round balers and hydroswings are 1000 so no problem there. You have 12 speeds and as long as the ta holds in high and low they seem to be geared fine for haying. The ta increases about as much as shifting from under to over in your white in any given gear, so its a little bit more of jump, but for baling it seems to work about right. I use mine for a lot of light work and in my opinion it is cheap on fuel. Dad has a white 2-155, which is about the same size and horsepower, but seems to like its fuel whether its working or not. I don't think the 1586 is any less nimble than a 9 or 1086, corners sharp, good visibility, and quiet cab.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Reflections of the Fifties - by "Country" Elliott. I remember rowing up in the 1950�s in a small, rural town in northwestern New Jersey. The closest town to ours was only 3 miles away, and there were seven dairy farms in the areas of these two country towns. We had 5 acres, and because my Dad was a salesman and not a dairy farmer, he let the Bockovens, who owned the Willow Tree Dairy farm most of our land.
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
