Posted by bryan iniowa on May 05, 2014 at 18:15:51 from (209.252.173.22):
In Reply to: Re: OT Basement posted by Pops1532 on May 05, 2014 at 14:42:17:
Thanks . Two bedrooms, bathroom, open area for bar etc . One room for my reloading bench and gun safes. They manhandled a power trowel down there. Did great job on finish. Used " Form a Drain" for footings. Its tied into sump pit. After solid week of rain I had about an inch of water in pit. The sump pit cover sticks up above floor a little. Wasn't required to have one but thought foolish not to. Also did 20 x 8 inch footing . 16 x 8 was code. Pretty happy to be at this point. Roughly four years working on it. Got burned out few times and took few breaks from it. Thanks for all the great advice and encouragement from everyone one here. There will be a party and your all invited!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
