[quote="Billy NY"](reply to post at 11:26:36 04/16/14) [/quote
Hey Billy NY, Well I power washed my front end of my tractor and using the front end loader I was able to lift it up and down to see all the movement in the front end, I have less than 1/8" of play in the center axle area around the pivot shaft, and movement between center axles and knee axles, spindles and very little in wheel bearings.
I noticed the 5/8" bolts holding the axles together were not all the same and some seemed to be missing so I went out and bought 8 new bolts,washers,lock washers and nuts. When replacing them some of the bolts were threaded all the way to the bolt head and had worn down were the axles were rubbing on them. After replacing all the axle bolts I let the front end down and it was 50% better than before.
Now on the spindles there was 1/8" movement also, are there bushing kits for them or do they need to be replaced?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Tinker�s Guide to Manifold Repairs - by Curtis Von Fange. A common characteristic of keeping older equipment is that some parts to make repairs can be extremely difficult to locate. For example, finding a replacement for a cracked intake or exhaust manifold on a unique tractor or odd brand can be a frustrating and downright impossible mission. So, what is an alternative solution to scraping out that �one of a kind� piece of history? First, decide if you are one to try a repair yourself or have someone else do it. If you are uncomfortable about
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
