Posted by ss55 on March 29, 2014 at 20:45:13 from (50.81.112.224):
In Reply to: Heat pumps posted by George Marsh on March 27, 2014 at 15:48:47:
Air to air heat pumps work well when outside air temperatures above 40_F or 5_C. They are not a very good application for areas that spend much time with outdoor air temperatures continuously below freeezing. When air temperatures are below freezing air to air heat pumps need a backup system, like electrical resistance heat. A good air to air heat pump system should automatically shut down when outside air temperatures are too cold and then automatically switch on their backup system. If you friend's system did not do that automatically, then I would believe either something is wrong with his system or someone sold him a wrong system, one intended for a warmer climate. If his system is regularly cycling heat outdoors to defrost the outdoor coils, it sounds like he has the wrong system for his climate.
Geothermal heat pumps are a better application where air temperatures are below freezing for long periods of time. This winter in Minnesota we had over 50 mornings with low temperatures below zero_F and we were continuously below freezing for a 30 day stretch. Air to air heat pumps are not used here except in three season porches that are unheated in the winter. The trade-off with geothermal is much higher installation costs.
Did your friend buy his air to air heat pump from a liscenced contractor? If an HVAC contractor is installing air to air heat exchangers as far north as central Indiana, my opinion is he is cheating his customers. The contractor may be getting a lot of sales by selling uninformed or gullible customers low cost systems that the customers think will do the job, rather than doing the math to quote the higher cost heating systems that his customers really need. That's just my opinion.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
