Posted by MarkB_MI on March 29, 2014 at 05:14:34 from (75.198.91.214):
In Reply to: Re: Heat pumps posted by George Marsh on March 28, 2014 at 08:24:02:
George, I don't know the reliability of your source, but it seems to agree with what everyone else is trying to tell you.
"...on a mild day, for example 10 �C, a typical air-source heat pump (ASHP) has a COP of 3 to 4..."
Translation: Under the conditions which heat pumps are designed to operate, they beat the snot out of resistance heat.
"...in extreme cold weather the COP approaches 1."
Translation: Under the worst possible conditions, heat pumps perform no more nor no less efficiently than resistance heat.
Excuse me if I misunderstand your point, but I think you've been trying to say that when it gets really cold resistance heat is cheaper to operate than a heat pump, and that's just not true. Resistance heat is ridiculously expensive, and I'd never own home heated by it in Michigan. (It does work nicely in our Florida condo, by the way.) Now, if you're trying to say that the total cost of ownership for a heat pump is more expensive than resistance heat, I'd say that depends. It's probably true in very mild climates where you don't need air conditioning and seldom need heat. Southern California is the only place I know like that, and even there nobody uses resistance heat since natural gas is readily available.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Ferguson TO-20 - by Staff. When the infamous "Handshake Agreement" between Henry Ford and Harry Ferguson fell by the wayside (that's a story in itself), Harry Ferguson quickly set up manufacturing plants for a United States version of his English TE-20. The TO-20 was relatively the same as the TE-20 except utilized some different casting materials and had a US-style electrical system. The TO-20 was a dead ringer for the Ford 9N and 2N models and they say that Ferguson did this on purpose when the Handshake Agreement wen
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
