Posted by rrlund on March 19, 2014 at 06:41:56 from (162.250.26.144):
In Reply to: Where is old? posted by Richard G. on March 18, 2014 at 17:51:16:
Copied and pasted from Site Comments Forum.
I just removed a post about a moderation issue and sent the person a private email.
We just discussed this issue of talking about moderation in the forums. In the past, Kim has deleted all posts talking about moderation, and I would prefer to do that in the Site Comments forum too.
Here's why. The matters related to moderation are private information between moderator enforcing terms of service, and the other person involved. The terms of service on YT are very clear and need no discussion, we have always tried to keep them very simple. But it is also not our place to talk with a third party about someone else and their side of whatever their disagreement with the terms of service might be. Based on this, there is no need to discuss moderation. For discussing terms of service, just use the Feedback Form, it goes directly to the moderator. You will find that in the left column menu of YT home page.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.