Posted by Donald Lehman on March 07, 2014 at 06:45:04 from (184.12.69.19):
In Reply to: pulling out a tree posted by 37Chief on March 06, 2014 at 20:35:03:
If this tree is around buildings or power lines, I would suggest gritting your teeth and hire it done unless you have had a lot of experience with this sort of thing. The fact that you are asking here about it suggests you don't have much experience with tree felling. Hire it done!
If it's out in a field just saw the darn thing down and worry about grubbing out the stump after the tree is safely down. If you "think" the tree is 50-60 ft tall then you need at least 150 of chain, cable or rope and 200 ft. would be safer. If that tree has any dead branches in it, you are attempting a VERY dangerous thing. A two or three inch diameter piece of dead branch flying across the yard could easily kill you if it hits you it the head or chest.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.