Posted by Hal/ Eastern WA on February 24, 2014 at 13:35:01 from (97.114.109.222):
In Reply to: Furnace Ignitor posted by El Toro on February 24, 2014 at 06:57:09:
I just had to replace the ignitor in my Rheem natural gas furnace last week. I believe the original one lasted more than 17 years.
The replacement part looks like the one in your photo, but mine cost me $50. It was fairly easy to replace and since the old one quit getting red hot, the problem was pretty easy to diagnose. When I checked the old part with my meter, it showed open.
It looks like the element on the new part is about half as thick as the old one was. I wonder if I will get anywhere near 17 years of use out of the replacement part? I bought a second one for a spare to keep on hand.
For the last year or so, my furnace would sometimes not stay lit on the first try, and the ignitor system would cycle again, sometimes 3 times until it would stay lit. I read in the manual that came with the furnace that the flame sensor should be cleaned with steel wool if the ignitor system cycles like that. So I figured out what the flame sensor must be and carefully cleaned it with fine steel wool. Since that time, the furnace has lit properly every time I watched it. I wonder if the failure of the original ignitor might have been at least partly caused by the dirty flame sensor causing the ignitor element to cycle so often.
If I have any more trouble with the furnace not staying lit like that, I will replace the flame sensor.
Other than changing filters, I have never worked on that furnace before. It has always worked just fine for me. Real glad I could fix it myself!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
