Posted by D Slater on February 22, 2014 at 16:29:06 from (184.14.211.223):
In Reply to: farmall M posted by dj1971 on February 22, 2014 at 13:38:29:
Need to use the M flywheel and clutch if the 47 liftall pump is in the center housing. If using the 400 flywheel a SM clutch and pressure plate is needed. Then you would need a liftall out of a late m or SM to clear the 12 inch pressure plate. Need to install a M type throttle lever in the 400 governor or install the complete M governor. ventilation line needs run from the top of the 400 valve cover to the air cleaner inlet where the M was. If using the 400 carburetor the choke rod needs bent to work on the engine side of the carburetor. If not using the 400 hydraulic pump a ignition drive housing from some 50 model M up or a SM. 47 housing has a different bolt pattern than a 400 front plate and cover is the reason for the change. That should be about it unless I forgot something.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - On the Road with Dave Gohl: Auction Musings - by Dave Gohl. I was thinking the other day about all the auctions I've been to in the last few years. There've been many. Some have been very good, some have been well, disappointing to say the least. But no matter how good or bad auctions may be, we always seem to stay until the item we've come for or are interested in is on the block. I've been to some auctions near and far. I think the furthest has been the Two Cylinder 7 in the Amana Colonies last year. Lots of stuff, lots of people. I've also atten
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
