Below your dash there is or should be a sheet metal cover over the hydraulic system 'blocks' or control valves. Remove same and review the above link. You will be looking for part reference number 13. Clean the area as best you can to help prevent any more debris from entering the system once you reinstall the removed parts.
Another area to check is the single to double acting 'knobs' you will see protruding on the vertical face of this same cover. There is a small roll pin that should be visible. It is 1/8" X 1 3/4" and is shown at reference number 16. It is possible this control knob is not turned completely to either a 'D' for double or 'S' for single (providing this little decal is in place on the frony of the cover) and/or the roll pin is missing. This is the first thing I would check; then proceed to the screen issue. I would suggest you post this subject on the Farmall IH discussion forum as more IH geared viewers can assist you if needed. Post back there with results, good or bad as others could learn from your problems. Good luck with your 560; hope this helps.
This post was edited by Al L. in Wisc. at 17:29:19 02/17/14.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractors and the City Boy - by Ken. A few years back I came to the conclusion that city life wasn�t for me. The houses so close together you could hear the neighbors fight, traffic so heavy speed limit signs meant nothing. So I started looking for the ultimate country setting. After many months I found the perfect place, off the beaten path, up a private � mile drive, old stone house which has stood the test of time, out buildings which haven�t stood the test of time, trees, birds, rabbits, and snakes. This is the place! Bought
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
