Posted by NCWayne on February 15, 2014 at 16:45:51 from (173.188.169.54):
In Reply to: ot i need help posted by ericlb on February 15, 2014 at 13:02:27:
You might give the folks at Faxon Auto Literature a call and see of they have a wiring diagram. We got a set of factory manuals for one of the old cab over Fords from them years ago and they had both the repair manuals and a separate set of prints just for the wiring.
Unfortunately, in a situation like you"ve got, there are usually so many wires that have been cut, shorted, etc, etc over the years that the best thing to do is to take them out and start fresh. That might not be as easy as it sounds without a diagram. However, given that the basic wiring diagram on those old vehicles are all pretty much the same, and color codes are often the same also, if you can find one for even a standard pickup it should cross directly, or nearly so, to what you need. Good luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
