Posted by PJH on February 15, 2014 at 13:27:50 from (50.40.225.157):
In Reply to: ot i need help posted by ericlb on February 15, 2014 at 13:02:27:
Looks like one of the Chevy truck forums would be able to come up with a good schematic for you. I have an old Ford, and I found everything I needed on the Ford Truck Enthusiasts forum.
One bad memory that I have about re-wiring turn signals - when I was in high school, I rewired an old Ford pickup. When I got done, the front signals came on with the brake lights, just like on the back. They flashed like they were supposed to, but those "brake lights" on the front got me a lot of ridicule from all of my buddies. I almost pulled my hair out before I figured out what I'd done wrong, and for the life of me, I can't remember how I fixed it - too many years have gone by, but I'll bet I lie awake tonight and dwell on it. . .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
