Posted by rustyfarmall on February 15, 2014 at 13:12:31 from (208.126.186.41):
In Reply to: ot i need help posted by ericlb on February 15, 2014 at 13:02:27:
Just about every truck I have ever been around, from 1/2 tons on up, has a very good wiring diagram in the owners manual. If the manual you have does not have the diagram for turn signals, which I believe WERE optional at that time, see if you can find a manual for a Chevy truck a few years newer. Your truck won't care if it is original or not.
If that truck was in my shop, I think I would totally remove ALL the old wiring and start from scratch with brand new wire. Don't even bother with trying to find a complete wiring harness. Just start from scratch.
If I remember right, the turn signals on most of those old trucks would function even with the ignition shut off.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
