Posted by Eldon (WA) on January 31, 2014 at 23:02:18 from (98.225.11.231):
In Reply to: Wet Sleeves posted by Jenny Lindsey on January 31, 2014 at 22:29:46:
Quoting Removed, click Modern View to see
I've done them a number of ways. If you have the engine apart and the crankshaft out you can drive them out with a hammer and a block of hard wood from the bottom. Turn the block over and set it on a couple of 4x4 blocks if you can.
You can also use a long piece of 3/4" threaded rod with a block on the bottom and a block bridged on the top and draw it up and out with a nut on the top (I would use this method if I was going to re-use the sleeves),
I would also think that you could use a piece of chain and drop it thru and wrap it around a block at the bottom and a long heavy pipe up above with a 4x4 as a fulcrum and basically use it like a big lever to pop them out. (I haven't tried this way yet).
They should come out fairly easy once they are flush with the bottom web as the O-rings will be out of the bore. Good luck!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Storing Your Tractor - by Staff. If your tractor is going to be stored for any length of time, a few precautionary measures are helpful in preserving various parts, also in avoiding future difficulty. Store tractor under cover. If impossible to place tractor under cover, be sure to cover air stack and exhaust pipe. Drain radiator and engine block. To avoid gum content collections, drain both fuel tanks and carburetor. Leave radiator and fuel caps slightly loose to protect gaskets. Block tractor up to remove weight from tires and to keep tires from contact with moist floor.
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
