If you want a nightmare for seed bed preparation, do a poor job plowing.
The sod needs to roll completely over and stay there. If it doesn't, you need to make adjustments. Otherwise, you're just making a mess and no amount of disking will fix it.
I'm speaking from experience. Tried plowing a sweet corn patch with my Cub and couldn't make the sod turn over. It just kept flopping back into the furrow. The ground had never been plowed before, so the plow would go from scraping along the surface to 12" deep in the blink of an eye so making adjustments was an exercise in futility. I started, so I had to finish. It was a mess. I spent hours bouncing over it with a disk and then a spring tooth harrow, and never did get it smooth. Then I planted corn. Then it rained, and rained, and rained. The weeds grew, but you couldn't even walk in the field let alone spray or cultivate. It was a total waste of time.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.