Posted by rusty6 on January 04, 2014 at 12:35:00 from (207.195.86.225):
In Reply to: Any Ideas? posted by Moline_guy on January 04, 2014 at 12:12:39:
I assumed all the newer rims had that extra offset hole in the centre to hook a chain in to carry and install. Thats what most of the Magnums here have including my 7130. I am assuming nobody runs with fluid in the outer duals . Wider spacing is good as I don't know how you would clean the mud out when they pack full of it. I've removed and installed my 20.8 38s myself. Just the front end loader and a chain hook through that extra hole in the rim I mentioned earlier. Get the wheel leaning up against the hub and then use a crow bar to rotate the dual til alignment is good. Helps to drive the inner wheel onto a piece of 2x10 so you have room to work.
This post was edited by rusty6 at 12:36:14 01/04/14.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Field Marshall Series 1 - by Anthony West. I had been restoring tractors for several years, and over that time had aquired a varied collection of machines of all ilk. I had started on Fordsons both standard and major, and from there progressed as my skills and knowledge increased. It had always been my ambition to own one of the rare types of tractor. The sort of machine that was eagerly talked about at meetings and gloated over lovingly at shows. One such machine was Field Marshall, I had heard many men talk of this machine with a p
... [Read Article]
Latest Ad:
John Deere 750 Diesel Yanmar J80TU engine. pistons and rings replaced when discovered crankshaft was bent. 3995 OBO Pictures available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.