Posted by Bret4207 on December 29, 2013 at 05:21:54 from (64.19.90.196):
In Reply to: chain saw bar posted by 1948jr on December 28, 2013 at 17:40:11:
The MS391 is a 64cc/3.9ci saw. You should be fine with a 20" .375 gauge bar. You could go with a .325 gauge chain too which is a little narrower. I find a 20" bar balances better for me than shorter bars on saws that size. I run a 20" on my 028 super. As long as I don't bury it and keep it sharp it's fine. My old back appreciates not having to bend over another 2-4"!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - When Push Comes to Shove - by Dave Patterson. When I was a �kid� (still am to a deree) about two I guess, my parents couldn�t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He�s been run over by a train, he�s gone forever!" Where did they find me? Perched up on the seat of the tractor. I�d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this �green planet�. I�m par
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
