Posted by Mark - IN. on December 25, 2013 at 16:25:32 from (98.215.76.204):
In Reply to: grinch posted by farmerwithmutt on December 25, 2013 at 05:41:40:
Farmer,
You aren't clear on what you sent in the mail, cash or check? If you sent cash, sorry, but that's why it is recommended to never send cash in the mail. If you sent a check, I would assume that your bank should be able to help you with a canceled check. I'm not sure why you want to take it out on the cops. Cops don't issue vehicle registrations, your state does through its department of motor vehicles, secretary of state, or whatever they call them. Taking your misfortune out on a cop for doing his job would be like yelling at your neighbor because the mailman mistakenly put your mail in his box. Your misfortune is not either of their faults.
I wish you better luck in the future, but what is done is done. How did you pay via the mail? Cash or check? Your payment may have never even made it to your state's department of motor vehicles. It may not have even made it to the postal service. It may have been stolen right out of your mailbox. The door of your mailbox may have opened and the letter blew out and down the road, currently lying in a creek. A couple of weeks ago during a windy snow on a bitterly cold day, after doing our driveway I shot down the road and did our sickly neighbor's drive, and after him the 80+ year old farmer's widow down across the road from him, and before I started, I went past her wide open mailbox and meant to close it, but it was full of mail that I grabbed and handed her at her door. A while longer and her mail might have been blowing across the fields. In any event, this might be a learning experience. Better luck in the future, and hopefully a Happier New Year for you and yours.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
