Posted by Tx Jim on December 17, 2013 at 03:50:14 from (69.35.160.119):
In Reply to: JD 6400 wheel weights posted by JD Seller on December 16, 2013 at 18:54:33:
JD Seller said: (quoted from post at 21:54:33 12/16/13)
The one like TxJim posted is a weight that is only used by the JD Mannheim tractors with flanged axles and is just about impossible to find used.
JD Seller
Sparktrician stated his tractor had rack & pinion rear wheels so this is the heading of the parts photo I posted: WEIGHTS FOR CAST REAR WHEELS 30", 34" AND 38" (PINION ADJUSTED AXLE) BUT maybe photo is titled incorrectly.. Since I left JD dealer before the 6400's were introduced my knowledge of them is limited. Here's the weights for a 30,40 or 50 series RC
This post was edited by Tx Jim at 04:01:10 12/17/13.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fabricating Sidesheets - by Chris Pratt. The easiest and best first-time project for wanna-be sheet-metal workers like myself is flat or nearly flat metal cut and drilled to be a tractor's sidesheet. A sidesheet is sheetmetal to cover either the engine as in the case of early Oliver's, Massey-Harris' and many crawlers or the wiring and electrical components as in the case of the Massey-Harris Pony, Allis Chalmers' D Series (D-14, D-15, D-12, D-10, D-17, and D-19). The need for fabricating becomes obvious when you go to buy any of these
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
