I bought a Farmall A in 1975 with a stuck engine. for $100.00 and that included the 16-inch moldboard plow. The head and pan was off and after looking at the sleeves I pulled the engine. I took a piece of oak and big hammer and I drove out several pistons and several the sleeves came out. I used a torch to heat the sleeves to remove the pistons. I steam cleaned the block to remove a lot of crud. The crankshaft just needed to be polished. It was worn .002" undersize. I bought the bearings from the same shop and had the head redone with new valves and springs. The tractor needed tires, rims, steering wheel, seat, fenders and new wiring. When this picture was taken I had finished plowing my garden and someone stopped to look at the tractor and wanted to know if a mower could be used. I told him to call the IH dealer and he came back and bought the tractor. I bought a Super C later. Hal PS: I would pull the head and see what the sleeves look like. If they're pitted I would do a complete teardown.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.