Posted by Don-Wi on December 06, 2013 at 18:18:42 from (66.87.79.51):
In Reply to: 95 f250 rear brakes posted by Don-Wi on December 06, 2013 at 11:29:42:
I'm just glad I can squeeze it in the garage. not much room behind and just enough room to walk in front, but it's all I need. It all started with the radius arm bushings being shot. figured I'd do the ball joints since I was in that far. then the shocks. then the brake hoses looked bad. then I looked in the drums....
Now, 15 minutes after all the stores are closed, here I sit ready to put the new wheel cylinder in and the old bolts are the wrong thread, and the new ones didn't come with any. the old ones are metric threads I think (8MM) and the new ones are 5/16. talk about frustrating.
Not too mention the new brakes hoses for the front didn't come with the retaining clips, and I didn't order them. Nobody local had then in stock that I have found yet. same with the copper washers for the banjo bolts...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.