gonna pay attention to this thread, i am in a similar boat as you except a little older (16), i already have a allis wd, but its my pulling tractor so it has ho hydraulics or lift arms, just a drawbar and a pto when my grandpa (who bought it for me) uses it for the auger tractor. one way to make money with minimal equiptment purchases is hay, square bales are a little easier to handle and in my area (nw iowa) go for a little more per ton, you can also get more square bales in the same size space as round bales. that being said, what do you have for land, or your parents/relatives have for land. without you really cant make money with your tractor unless you would do custom bailing per say but then you should have a 3/4 or bigger pickup to hual the tractor and or bales, or you could rent land, which isnt very practical for this situation. a little more info is needed to give you an accurate answer, but good luck to you,
also what kind of hp numbers were you thinking, or basically how big and how new of a tractor did you have in mind
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Farmall Story - by Ed Meadors. The year was 1978. Our young family had recently moved to rural Chesapeake, Virginia to a plot of land which would finally allow us to realize our dreams of a huge garden, critters and more lawn and pasture than we would ever use! We needed a TRACTOR; not a riding mower or tractor wannabe, but a real TRACTOR. The answer to our needs materialized in the form of a '44 Farmall A, complete with cultivators, discs, single plow, a 5ft.Woods belly mower and one, mounted spare 9.00x24 rear wheel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.