Posted by Paul in MN on October 31, 2013 at 19:48:13 from (174.20.130.38):
In Reply to: bolt sizes, length posted by ejensen on October 31, 2013 at 12:14:17:
The bolt that has the ears for engaging the hand crank on the front of the crankshaft is a standard right hand thread 5/8" N.C. I think it is about 2" long, but that may vary with the thickness of the hub of your replacement pulley. If I was going to drive 100 miles to change the crank stud out, I'd bring a selection of bolt lengths from 1 1/2" to 2 1/2" grade 5 5/8" N.C. with appropriate washers. The fender bolts do not have to be carriage bolts. Unless you go to a tractor dealer, you will probably not find grade 5 carriage bolts. The "standard" carriage bolts are a much softer steel and will probably stretch over time making the fenders loose or rattely. I have used standard hex head grade 5 5/8" bolts for this application. The bolt length needed will vary with your loader and stabilizer brackets, so I'd bring a selection of them as well.
All this is from memory, and I can't find my parts book right now to confirm, so you may want to check with some other sources.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - More Memories of a Field Service Engineer - by Brian Dye. Introduction: The author worked for one of the largest Ford tractor dealerships in England as a trouble-shooter on tractor engines, hydraulics and combine harvesters from 1963 to 1972. In 1972 he became a dealer manager and finally left the dealer net in 1975 to run his own electronic design and manufacturing company. [Editor] We live right in the middle of Norfolk. The dealership that I worked for sold Fordson Tractors from the 1920's and some of t
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
