Posted by Rick Kr on October 23, 2013 at 08:50:05 from (198.208.251.48):
I am looking for the dimensions on a JD MFWD front rim off the newer utilities, 5325, 5425, 5055e, 5065e, etc.
I am trying to go to R4s on my NH3930 and not having much luck finding 18" rims. 16.5" rims will not give me the right tire height to keep the 4wd ratios right.
The measurements off my NH front rim are: 8 lug, 8 5/8 inch center hole, and approximately 10 3/4 inch lug spacing (~285mm)
Seems Ford/NH outfitted a few utility tractors with a 20" rim with R4s, but no luck finding any. The 18" R4 on the front of the JDs looks real close, and more common. Worthington Ag is looking for a few right now, but I need to verify hub and lug dimensions first.
Right now I have 9.5x24 R1s on the front, cant find that dimension in an R4 anywhere.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.