Posted by Tom Bond on October 04, 2013 at 20:40:56 from (98.212.12.115):
I'm putting my mower deck back together after replacing 2 destroyed blade driver bearings. Can't find a definitive answer anywhere on what the nut torque should be on a 1/2", zinc plated, grade 5 bolt and nylon lock nut. They are the bolts that mount the bearing assembly to the deck. I've seen everything from 45 ft. lbs. to 150 ft. lbs.. I locked the nuts down at 100#. I'm just a bit concerned that might be a tad too much for a 1/2" bolt and don't want this thing coming apart 250 miles from here where I use it on a food plot. Would anyone know what the torque spec for the nut should be? Am I over? Or under? Or should I just quit being picky about a mounting bolt and leave it as is at 100#? Thanks!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Haying Before Tractors - by Owen Clark. Hi guys! At age 8 (1927, am now 79) I was learning how to drive a stacker team on the old homemade A-frame wooden stacker, on three of my uncles` dairy farms in Star Valley Wyoming (south of Jackson Hole, on the Wyoming-Idaho border). There was one steam tractor in the Valley, owned by an entrepeneur who used it to run his grain threshing machine, that he hauled from farm to farm for the fall harvest. We used teams of horses not only on the stacker, but on the buckrake to buck the dried
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
