Google 'stray voltage' and you'll probably find some information on it. Basically you take a multimeter, set it on the AC voltage setting and test from the water trough directly to the ground where you're standing. Technically I believe you're supposed to use a small resistor in series with the test leads to simulate some load. If you find some of the online articles it may give you the value of that resistor... Regardless if you use a resistor... test from the tank to earth and what you see is what you got.
You can also try doing your tests with your main entrance shut off and see if the tingle voltage isn't coming in on the neutral. That's a pretty common thing because of bad grounds on the utility end... and be damned if they'll ever admit that ~they~ have a problem. You may end up getting a tingle voltage filter if you find it's coming in on the neutral. The other option you have is to construct a steel reinforced concrete pad that has a grid of steel tied to the safety ground system. The idea is to create a voltage plane where the tank and the pad that the animals are standing on are all at the same voltage potential... thus they won't get a shock... except mabey when they step onto the pad.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Ford 600 Series - by Staff. The Ford 600 Series tractors bean production in 1954, and continued until 1957. Quite similar to the Ford NAA (Golden Jubilee) in design, it used the same 132 cubic inch Red Tiger engine with 31 horsepower. Several different models were made in the 600 Series, and these numbers were used to denote whether they used a particular transmission, hydraulic system, or PTO. The result was five different model numbers: 620, 630, 640, 650 and 660. These break down as follows:
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
