Posted by rust-o on June 21, 2013 at 18:39:30 from (75.197.177.38):
alright so i have a massey 165 and it seems as if it has a bit of a hydraulic issue. The tractor was just in the shop cause i completely lost hydraulic pressure, both at the remotes and at the lift arms. They though it might be the pump but then they decided it wasn't (super happy bout that) but they did some other work to it and said it was good to go. The remotes now work ok and the 3point hitch does too but the 3 point hitch especialy is really slow. I have the response lever the whole way up at fast and it still takes a good bit of time to raise up an implement. Even stranger it takes a good while for the implement to go down. Anther issue with it is that when you go to hook up to an implement the lift arms will not go down unless you get off the tractor and go back and jump on them. no matter what you do with either lever. they will not go down without wieght. So is this normal? i dont figure that it is but i would think that after spending 2500 at the MF place it should work like any other tractor.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
