Posted by Adirondack case guy on June 07, 2013 at 11:33:22 from (74.69.160.79):
In Reply to: 706 and a 2000 loader posted by IH706operator on June 07, 2013 at 10:14:59:
It is very easy to fab mounts for the 2000 loader. We made lots of them when we were Case dealers. the 2000 loader was made by Great Bend, as was the case loaders. Here are very simple mtgs that are strong and easy to make. I posted this quick sketch for another fellow last week, who wanted to put a 800 GB ldr. on a Case 870. This will work on your 706 just fine. The front bracket goes across the front of your tractor and the 6" angles clamp under your rear axles. If you want to get fancy you can fab up a saddle on the end of the 6" angle to clamp the ldr. strut into, but welding it to the strut works just as well. Loren, the Acg.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Machine Shops - by Curtis Von Fange. It is a story that repeats itself countless times. In the process of rebuilding a particular section of the tractor there is a broken part for which a replacement cannot be found. The parts houses find in their catalogue that it is unavailable. The dealerships call it a discontinued part. Salvage yards define it as hard to find or, even worse, rare. Everyone on the NET says, 'what is it?' But don�t despair there is another avenue that can be used to get that piece repaired. The local mach
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
