Posted by Gambles on May 24, 2013 at 19:53:46 from (24.246.215.127):
In Reply to: old gasoline posted by ih10020 on May 24, 2013 at 15:16:28:
Make sure you mix it. Last summer, I was running a gas forklift. When there was probably less than a cup of gas left in the tank, I put in about 5 gallon of two-year-old gas. I started the forklift back up and as soon as the old gas made it to the carb, I had to pull the choke out all the way for it to run. It actually ran okay, as long as the choke was pulled all the way out. I was pretty proud of myself because I was going to get rid of some old gas.....until I had to do a cold start on the forklift. I had a heck of a time getting it to start next time and I actually had to unscrew a plug out of the intake manifold to shoot some ether in it to get it to start. I was actually pretty happy to get all of the old gas burned out of the tank. After it was gone, the engine would again run with the choke all the way in.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
