Mark, thanks for the details on the basic principle of how the A/C works. I always wondered how these darned things do what they do to cool air and make things comfortable.
So in essence, more modern units went with the slinger so that it cools the condenser more efficiency by making use of that condensate in the pan. However like you say, that creates the problem above which does as you describe, makes the compressor work harder to compress the refrigerant, if those coils are hotter because the air flow is restricted by the felt like sheet of dust, like in the photo.
What I wonder is, like the old units and they worked fine, maybe more wattage but still, is this "slinger design" that further cools or consistently lowers the coil temperature further than the previous designs that did not sling water on the coil, really any better, given the propensity to collect dust and do the above, mind you which was years worth, maybe since new. I would imagine one seasons worth may or may not be nearly as much but after some run time, its likely to still coat enough to restrict the air flow and then you are no better off than if it was not slinging water because the coil is not 100% clean. I would assume there is some loss built into the coil size and or how the unit is built. I am now wondering should I silicon up the weep hole or just leave as is, its nice to know the coil stays clean, per the almost nil accumulation from last season, it needed almost no cleaning at all, seems to me you are right the increased dust accumulation, all makes sense now, thanks for posting this !
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.