Posted by Dave Gunem on May 14, 2013 at 16:05:28 from (174.124.116.250):
In Reply to: Re: John Deere 720 LP posted by deerenutz52 on May 14, 2013 at 15:24:58:
I have six 2cyl LP tractors [ 1-730,3-630 & 2-620 ] and have not had any issues with grille tanks . Pretty standard when I get a new one that hasn"t run in a while { seems most fit into this category ] to just hook a grille tank to the convertor to get it going . Used both new and old grille tanks and it didn"t make any difference . Now at full snort this may be an issue but for what you"re doing it shouldn"t be . These things are pretty simple and it sounds like your biggest issue is poor compression . Remember LP tractors are supposed to have more compression than gas ones . The compression you state isn"t enough to run it . When all is well and it hits on a cylinder it will hit REAL HARD .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.