Heres how to wire it, same info I already posted below but you asked again and Im here to help best I can:
BAT on VR to Load (NOT battery/starter) side of ammeter
FLD on VR to gennys FLD Post
ARM/GEN on VR to gennys ARM post
LOAD on VR wires up to BAT INPUT terminal on lights or ignition switch, it furnishes hot battery voltage for loads.
Often on those 4 terminal VR"s GEN/ARM is off on one side or underneath all alone
If the VR isnt marked, one thats open circuit to case frame is BAT,,,,,One with very low ohms to case frame is FLD,,,,,,,One with maybe 20 to 50 ohms to case is GEN/ARM,,,,,,,,LOAD terminal has low resistance over to BAT terminal
The VR DOES NOT GET POLARIZED, ONLY the Genny, so if its polarized youre good to go.....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
