Re: Re: Re: Re: Re: Re: Slip Clutch - Ferguson TO-20
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk ]
Posted by Dave on June 22, 1998 at 09:53:53:
In Reply to: Re: Re: Re: Re: Re: Slip Clutch - Ferguson TO-20 posted by Brandt Lawson on June 20, 1998 at 19:34:24:
: Your new overrunning pto clutch is bad or improperly
: installed. When it is working properly, pushing in
: the foot clutch while bush-hogging will result in
: a "rachet" or click-click-clicking from the
: overrunning clutch just like a rachet wrench clicks
: when returning it after a power stroke. : Be careful on installation. There is a pin to drive
: thru the outside case and center on the pto shaft.
: If it is not centered inside the overrunning clutch,
: it may catch between the overruning housing and the
: stationary pto shaft. Other that a defective clutch,
: this is only thing that I can think of to go wrong.
Brandt: I checked the pin inside the PTO clutch and sure enough, pin was not centered by about 1/8". I center the pin exact and the slip clutch is working great. Thanks alot, you saved me a lot of headache. I appreciate it.
Follow Ups:
Post a Followup
|
