Posted by Tony in Mass. on March 25, 2013 at 21:00:00 from (76.127.225.182):
In Reply to: Reloading safety.Pics posted by LOU from Wi. on March 25, 2013 at 19:24:55:
Is this soft lead or FMJ? Lead won't usually bulge the brass, but hardball will, so will the expanding die not adjusted right. Study the brass closely before and after the resizing die, and study again after you seat the bullet. Atleast you will know which process is deforming them. A hot load will distort the casing too, and just keep checking every shell at evey stage with the dial caliper. Now remember, never force a round into a chamber, if it don't go, it's a no go, stop. Some barrels have no 'leed in' so bullet head can dig into rifling, but action should close normally. These aren't unsually heavy bullets are they? And.... that new win brass might just be too thin... mike the thickness of that too....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
