Posted by robgIN on March 09, 2013 at 19:49:19 from (70.224.42.107):
In Reply to: Points of view posted by NCWayne on March 09, 2013 at 15:55:47:
I spent countless hours riding on tractors when I was very young and I enjoyed every minute of it. I sat on the toolbox of our SMTA and held on to the PTO lever , or on the toolbox of the 350U, and on the left axle tube of our Farmall B, but we had a pipe from the fender to the top of the trans to hold on to. Like everyone else said there is risk in everything including old tractors, but I was told about the dangers, and I learned to respect farm machinery. I also remember a few one armed farmers growing up that forgot to respect corn pickers. It is a tradegy when someone is injured or killed be it on a tractor or anything else, but I think life would be a lot simpler for everyone if we could just go back to using common sense . Too bad it is such an uncommon comodity in todays society.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
