^^^Unquestionably the most useful statment made up to this point regardless who's rules are in place.
Sparktrician,if you consider yourself a leader capiable of turning the club around,you may as well expect many fastballs along the way. You should also not ask for opinions or advise if you intend accepting only what you like. Questions will be asked by members regarding how dicissions were made,money was spent and other issues along the way. Although your intentions are good,you may not be the man for the job albeit better than prior ones. When I asked about poor leadership and bad money management leading to the need for"QUICK CASH" in your "TRACTOR CLUB ISSUES" thread,your response was either not well thought out or is an outright politician's tactic. Your exact words were,
This has nothing to do with current
officers / directors. This issue has been coming for a long
time. This is my first year as president
Now you start another thread saying that indeed there has been terrible passed leadership problems attributed to inability in handeling a single member who runs things using a rule book.
Your answer to my question should have been along the line of, yes Mr. potential life time membership buyer,we have experienced problems that resulted in the present situation but we have new direction now and are determined to grow the club with new leadership.
The impression I get is you are far too concurned with redirecting blame and fault to take objective views because you feel like you are being atacked personaly.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.