Posted by Greg K on February 12, 2013 at 19:22:12 from (75.107.96.58):
I went to look at a job today, and inside there was a very large Fairbanks Morse engine. I suppose it had 10 cylinders and stood about 8' tall. It was an opposed cylinder engine like I had never seen. It had a crankshaft on the top and bottom and the pistons shared the cylinders. when the two pistons came together it created the compression to ignite the diesel. When it fires both pistons go away from the center and exhaust the gasses out the vented cylinder walls (like a 2 cycle). At a quick glance I think the tag said 1500 horsepower, but I'm not for sure on that. I do know it is dual fuel diesel/natural gas, it holds 250 gallons of oil, and new cylinder sleeves are about $7000 apiece! You could easily drop a coffee can down the cylinders. If I get a chance I will get a few pics. It is on a power plant generator system.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
