|
Tractor Talk Discussion Board |
Re: Ford f250 E40D reliablility??
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob on June 07, 2007 at 07:51:27 from (69.178.229.154):
In Reply to: Re: Ford f250 E40D reliablility?? posted by jdemaris on June 07, 2007 at 07:41:05:
We've all done DUMB things. I don't even care to THINK of some of mine! ($$$$) However, I think you are making that tranny out to be MUCH worse than it REALLY is. (And, I'm a GM guy!) Also, something went wrong when you "scanned" it. If that tranny isn't shifting up for ANY reason, the 'puter's gonna know about it, and have something to say about it! I don't think it's possible to NOT have any codes, with the tranny stuck in "1". A scanner will tell you which shift solenoids are "active", and there are pressure test ports to verify if each solenoid is "doing it's thing" or not, pointing to a stuck solenoid, or a bad seal/clutch pack.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
