Posted by 641Dave on January 28, 2013 at 07:26:28 from (64.221.11.221):
That is right before it died.
My starter started smoking a little and I noticed it coming out from around the ring cover that covers the brushes.
It finally quit on me and all I get is a high frequency whine sound now.
I took the starter off and removed the cover and sure enough, half a cup of dry, dust crap fell out.
Two of the brush springs are resting on the guide arms and the other two are right there at it. The copper sleeve that the brushes ride on is a little scuffed up too.
Now what? Should I order a starter rebuild kit and replace the brushes or should I just go ahead and order a remanufactured starter?
Also, do you think that now that I have the crud dumped out, could I spray a little wd-40 on the brushes and see if it'll turn with just having it held in the bench vise and hooking jumper cables to it?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.