Posted by Indiana Ken on January 19, 2013 at 18:06:58 from (66.249.232.131):
In Reply to: Gas Line Anti Freeze posted by Pete-IN on January 19, 2013 at 05:32:25:
As others have posted you should not have gas line freeze ups when using E-10 fuel. Any free water present should not freeze and will go back into solution at the next fill up.
You can prove it to yourself if you like: Take 48 oz (3 pints) of E-10 fuel and add 1 oz of water. Shake or stir and allow to settle, you should see a water/ethanol phase form at the bottom of the container. If you place the container in the freezer (leave outside if cold) it should remain liquid.
The fuel above the water/ethanol phase is straight gasoline. If you pour off the gasoline and again add 1 oz of water as before you will note the water will freeze - don't try this in your freezer with a glass container. This is why we needed Heet before E-10 fuel.
You may find it interesting to note: At 70 degrees F, E-10 will absorb approximately 0.5% water by volume before phase separation occurs as compared to straight gasoline which will absorb approximately 0.02%. One of the ways water enters fuel is by condesation of humid air inside a less than full fuel tank. The amount of water condensed in this manner is the same regardless of the fuel in the tank, E-10 or straight gasoline. From this one can expect less chance of free water when using E-10 blends versus straight gasoline since E-10 can hold much more water.
From my experience: As a kid I remember periodically removing the sediment bowl on our 8N Ford to empty out the water. I have had my 8N for over 10 years now and use E-10 fuel - I have never observed water in the sediment bowl.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Perfect Restoration - by Chris Pratt. Often, in quiet moments, I have wandered back in my thouhts to the many tractors I have seen over the years and wondered which one inspired me the most. Sure, we have a fond attachment to one brand and model or another, sometimes it was remembering that first time we got to climb up in the drivers seat and command that roaring beast, or maybe because when you see that special model, you can't help but see Dad on it, he's gone, but everytime you see a tractor like his, it's a like part of him i
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
