your best bet is to run a 3wire(blk red wht &grnd) nm or thhn, depending on your current wiring in your shop, from the light to the outlet. This is dependent on wether the circuit is in that box already, Switched and unswitched need to be at the light. once run to the outlet you could put in a double duplex(2outlets)run blk to unswitched outlet red to switched outlet, the neutral then is pigtailed to both outlets. gfci will work on unswitched just fine, but the switched one may be tricky. Some gfci's need to be reset when they loose power. If you can't install two seperate outlets, run the white to the neutral screw, break the tab between screws on the hot side. If you then want gfci protection, buy a corded gfci, for the unswitched side and try to us only battery charger in other. Is the light circuit, and it's wiring rated to operate the lights and outlets? good luck
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.