Posted by Bkpigs on January 14, 2013 at 17:27:12 from (24.182.229.14):
Thinking of wiring half of one of my outlets in my shop to turn off with the lights. Leaving my battery charger for my cordless tools plugged in scares me and forgetting to plug it in ticks me off when I need a fresh battery.
I know I can run a single hot wire from a light box and to the oultet and use the neutral as shared between the light operated socket and the rest of the outlets. Since they are on different legs any additional current run through the charger would cancel the same amount of current running through the other sockets in regard to the shared neutral (no worries of overloading an unprotected neutral). My question is, if the neutral were to somehow lose connection with the neutral bar wouldn't that fry everything on that circuit? Essentially making the lights 220v? Also, I am guessing that the low Earth potential of the neutral keeps the power from back feeding the hots and making them 220v, is that right?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.