There are several differences in them. One is the length of the center pedestal, there are longer and shorter ones. Then there are arm and spindle differences too. The early New generations ones had issues with breaking the spindle arms. So they made heavier ones. The heavier ones have a four bolt bearing cap where the light has a three bolt bearing cap.
To really be sure you have the right one you need to check the center pedestal casting number. I don't have that number for a JD 530. I bet that some one over on th JD forum would know it.
If your Schwartz front end is the correct one it very well could have the JD hubs on it. When they where sold new you used the hubs off of your old narrow front on the new Schwartz axle.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Reflections of the Fifties - by "Country" Elliott. I remember rowing up in the 1950�s in a small, rural town in northwestern New Jersey. The closest town to ours was only 3 miles away, and there were seven dairy farms in the areas of these two country towns. We had 5 acres, and because my Dad was a salesman and not a dairy farmer, he let the Bockovens, who owned the Willow Tree Dairy farm most of our land.
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
