Posted by Jiles on January 01, 2013 at 11:00:45 from (69.137.20.229):
I have worked on small engines for over 50 years and have never seen an engine, of any type, that I could not get running----until now!!!
As many of you are aware, major changes and improvements have been accomplished with ignition systems.
That's where I think my problem is.
The chainsaw is a CS330t that was given to me by a friend. He knew nothing of the history. and the saw is in above average condition.
Here's the situation---
Compresson is 160#
Ignition spark will jump 1/4"--STRONG
Carburetor is new and getting fuel. No different then the Original that I rebuilt.
Crank seals passed test.
This is the FIRST engine I have ever seen that will not make the first effort to start!!! Not even a "fart"!!!!! Not even with different volumes of starting fluid.
This absoluteny makes no sense and I strongly believe it is in the ignition.
I guess I would like a little education about how these new coils work and what controls the Ignition Before Top Dead Center?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
