LOL Bret, Yea, if my typing was as accurate as that .22. My 100 yrd target is measured with a tape from the bench to the target board. It might be off a foot or 2 but it's pretty darn close. My shooting bench is built from plans found on the internet, wood, 4"x4" legs and 2"x6" framing so it's very solid. We set in a low spot that is sheltered. Right now as I'm typing the wind along my shooting lane is 2MPH from the north gusting to 4. I have one of those home weather stations. The Baro pressure is 30.00 and it's 14.8F. If there is any wind above about 5 I don't zero or shoot groups as I'm checking the accuracy of a gun not trying to see if I can compensate for the wind. Next time I do some shooting (about 3 months, it's cold right now) I'll try to remember to shoot some groups with it and post pictures of the target.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Machine Shops - by Curtis Von Fange. It is a story that repeats itself countless times. In the process of rebuilding a particular section of the tractor there is a broken part for which a replacement cannot be found. The parts houses find in their catalogue that it is unavailable. The dealerships call it a discontinued part. Salvage yards define it as hard to find or, even worse, rare. Everyone on the NET says, 'what is it?' But don�t despair there is another avenue that can be used to get that piece repaired. The local mach
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
