oldtanker said: (quoted from post at 10:42:22 12/17/12)
jackinok said: (quoted from post at 09:49:25 12/17/12) look at a rimfire target, how small is the 10 ring?Thats how small of groups REALLY good target shooters shoot. normal COMPETITION ranges ,are 25 ft, 25 yards,50 yards and 100 yards. one thing to remember,there is about 1000 different brands and loads in 22lr cal. in fact it is one of the most highly developed loads there are.believe it or not if your shooting regular cartridges like you buy at walmart you probably wont get any really good accuracy.
Jack, if off a bench and rest I'll bet you with an unbiast shooter on the trigger, that you will see decent groups with "birick" ammo out to 50 yds and maybe 100 depending on the brand as compared to match grade ammo. Some guns like a certain brand of ammo so a person will need to experiment to find the one that shoots best from thier gun. My CZ shoots sum MOA at 100 yds with Blazer brick ammo. They really have improved quality control.
Rick
I'm sorry, are you saying that with 22 LR Blazer ammo you shoot 10 shot groups under an inch at 100 yards? The world record for 5-5 shot groups average is .604. You'd better get to the nationals quick, big bucks await.
This post was edited by Bret4207 at 15:27:25 12/17/12 2 times.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Machine Shops - by Curtis Von Fange. It is a story that repeats itself countless times. In the process of rebuilding a particular section of the tractor there is a broken part for which a replacement cannot be found. The parts houses find in their catalogue that it is unavailable. The dealerships call it a discontinued part. Salvage yards define it as hard to find or, even worse, rare. Everyone on the NET says, 'what is it?' But don�t despair there is another avenue that can be used to get that piece repaired. The local mach
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
