Well it was good enough when they taught me how to shoot and hold a pattern at 1000 yards in the Army. We where using dummy ammo but a .22 rifle is not going to hurt the firing pin by dry firing it. There is no other way to "feel" the trigger pull accurately. Unless you know exactly when the trigger is going to fire the shot how are you going to be accurate???
Maybe if you want to be a half good shot you do not have to have that knowledge. If you want to be a good shot you need to know that for every gun you own/use.
I own a pair of Colt 1911 45 cal pistols. I have shot over 20,000 rounds through them. I can tell you within thousandths when they are going to fire. I have won bets with my sons over this. A small piece of clay under the trigger will measure how far you pull the trigger. Pull as close as you can to not firing. Then do it over and make it fire. You can measure the difference. I have done it with the difference being under .005 between the two. Used to be able to get under .003. Hands are not as good any more.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
